11 ATTACHMENTS 6 TO 13 - Laserfiche WebLink

A5.504.2.1.3 Noncomplying building areas. For each sampling area of the building exceeding the maximum concentrations specified in Section A5.504.2.1.1, flush out with outside air and retest samples taken from the same area. Repeat the procedures until testing demonstrates compliance. A5.504.4.6.1 Verification of compliance. Documentation shall be provided verifying that resilient flooring materials meet the pollutant emission limits. A5.504.4.7.1 Resilient flooring systems. For 100 percent of floor area scheduled to receive resilient flooring, install resilient flooring complying with the VOC- emission limits defined in the 2009 CHPS criteria and listed on its Low - emitting Materials List (or Product Registry) or certified under the FloorScore program of the Resilient Floor Covering Institute, A5.504.4.7.2 Verification of compliance. Documentation shall be provided verifying that resilient flooring materials meet the pollutant emission limits. A5.504.4.8.1 Thermal insulation, Tier 2. Install No -Added Formaldehyde thermal insulation in addition to meeting Section A5.504.4.8. A5.504.4.8.2 Veriflcation of compliance. Documentation shall be provided verifying that thermal insulation materials meet the pollutant emission limits. A5.504.4.9 Acoustical ceilings and wall panels. Comply with Chapter 8 in Title 24, Part 2 and with the VOC- emission limits defined in the 2009 CHPS criteria and listed on its Low - emitting Materials List (or Product Registry). A5.504.4.9.1 Verification of compliance. Documentation shall be provided verifying that acoustical finish materials meet the pollutant emission limits. A5.504.5 Hazardous particulates and chemical pollutants. Minimize and control pollutant entry into buildings and cross - contamination of regularly occupied areas. A5.504.5.1 Entryway systems. Install permanent entryway systems measuring at least six feet in the primary direction of travel to capture dirt and particulates at entryways directly connected to the outdoors as listed in Items 1 through 3 in Section A5.504.5.1. A5.504.5.2 Isolation of pollutant sources. In rooms where activities produce hazardous fumes or chemicals, exhaust them and isolate them from their adjacent rooms as listed in Items 1 through 3 in Section A5.504.5.2. A5.504.5.3.1 Filters. In mechanically ventilated buildings, provide regularly occupied areas of the building with air filtration media for outside and return air prior to occupancy that provides at least a MERV of 11. Environmental Comfort A5.507.1 Lighting and thermal comfort controls. Provide controls in the workplace as described in Sections A5.507.1.1 and A5.507.1.2. A5.507.1.1 Single- occupant spaces. Provide individual controls that meet energy use requirements in the 2007 California Energy Code by Sections A5.507.1.1.1 and A5.507.1.1.2. A5.507.1.1.1 Lighting. Provide individual task lighting and/or daylighting controls for at least 90 percent of the building occupants. A5.507.1.1.2 Thermal comfort. Provide individual thermal comfort controls for at least 50 percent of the building occupants by Items 1 and 2 in Section A5.507.1.1.2. A5.507.1.2 Multi- occupant spaces. Provide lighting and thermal comfort system controls for all shared multi- occupant spaces. A5.507.2 Daylight. Provide daylit spaces as required for toplighting and sidelighting in the 2007 California Energy Code. In constructing a design, consider Items 1 through 4 in Section A5.507.3. A5.507.3 Views. Achieve direct line of sight to the outdoor environment via vision glazing between 2 and 7'6" above finish floor for building occupants in 90 percent of all regularly occupied areas. A5.507.3.1 Interior office spaces. Entire areas of interior office spaces may be included in the calculation if at least 75 percent of each area has direct line of sight to perimeter vision glazing. A5.507.3.2 Multi-occupant spaces. Include in the calculation the square footage with direct line of sight to perimeter vision glazing. Outdoor Air Quality 5.508.1 Ozone depletion and global warming reductions. Installations of HVAC, refrigeration and fire suppression equipment shall comply with Sections 5.508.1.1 and 5.508.1.2. Note: This general informational handout is provided as a courtesy. Specific questions should be addressed to the project architect, contractor, other design professional, or by more detailed consideration of Pleasanton Municipal Code Chapter 20.26 and the California Green Building Standards Code (CALGreen 2010) at Title 24 Cal. Code of Regulations, Part 11.