18 - Laserfiche WebLink

Livermore-Pleasanton Fire Department 112. The project developer shall keep the site free of fire hazards from the start of lumber construction until the final inspection. 113. Prior to any construction framing, the project developer shall provide adequate fire protection facilities, including, but not limited to a water supply and water flow in conformance to the City's Fire Department Standards able to suppress a major fire. 114. The Fire Prevention Bureau reviews building/civil drawings for conceptual on-site fire mains and fire hydrant locations only. Plan check comments and approvals DO NOT INCLUDE: a. Installation of the on-site fire mains and fire hydrants. Specific installation drawings submitted by the licensed underground fire protection contractor shall be submitted to the Fire Prevention Bureau for approval. b. Backflow prevention or connections to the public water mains. 115. Electrical conduit shall be provided to each fire protection system control valve including all valve(s) at the water connections. The Livermore-Pleasanton Fire Department requires electronic supervision of all valves for automatic sprinkler systems and fire protection systems. 116. The following items will be provided prior to any construction above the foundation or slab. NOTE: Periodic inspections will be made for compliance. a. Emergency vehicle access will be required to be provided to the site (tract), including the area where construction is occurring. b. Emergency vehicle access shall be a minimum of 20 feet in clear width. A clear height free of obstructions (power, cable, telephone lines, tree limbs, etc.) is required. This clearance shall be a minimum of 13 feet-6 inches. Inside turning radius of 45 feet and outside turning radius of 55 feet shall be provided. c. Buildings or portions of buildings or facilities exceeding 30 feet (9144 mm) in height, measured to the roof eave, above the lowest level of fire department vehicle access shall be provided with approved fire apparatus access roads capable of accommodating fire department aerial apparatus. Fire apparatus access roads shall have a minimum unobstructed width of 26 feet in the immediate vicinity of any building or portion of building more than 30 feet (9144 mm) in height. At least one of the required access routes meeting this condition shall be located within a minimum of 15 feet (4572 mm) and a maximum of 30 feet (9144 mm) from the building, and shall be positioned parallel to one entire side of the building. P16-1384, P16-1386, P17-0155 & PUD-113, Ponderosa Homes II, INC. City Council Page 20 of 30