12 - Laserfiche WebLink

LD /116� 180 Industrial Drive Burlington,WI 53105 USA Phone:800-558-5986 Fax:(262)763.0156 CUSTOM SPECIALTY VEHICLES Direct:+1(262)763.0147 www.ldvusa.com Item Qty 9.00 HVAC SYSTEM: 9.01 3 Ducted low profile rooftop air conditioner controlled through the multiplex system. Includes: • 15,000 nominal Btu/hr air conditioner with condensate pump. • Chill Grille Assembly with 6,000 Btu/hr heat strip • Louvered Ceiling Vents, as required 10.00 AC ELECTRICAL SYSTEM: 10.01 1 Power Tech 20-kW 120/240Vac liquid-cooled diesel generator with air bag mounts installed in a custom fabricated compartment. Generator features: • Tier 4F Emissions • USTC Certified Manufacturer •Warranty: 2 years from date of purchase, or 3000 hours whichever comes first, or 36 months from the date of manufacture. • Four point air bag mounting system • Four-cycle water cooled diesel engine • Radiator cooled, direct mounted • High-coolant temp and low oil pressure shutdown sensors • Spin-on fuel and oil filter • Single side service •Typical Gallon Per Hour fuel consumption: 25% load = 0.45, 50% load = 0.90, 100% load = 1.80 Compartment shall be constructed to the following specifications: • 0.187" aluminum with all welded seams. •2" deep 0.125" aluminum box pan doors and 0.125" aluminum frames. • Door frames riveted to the body and welded to the compartments. • Stainless steel door hinges attached with stainless steel machine screws. • Flush mounted door handles with slam latches. • 0.100"aluminum treadplate panels on interior door surfaces. • Gas charged lift/support cylinders to hold doors open at 90°. • Industrial grade neoprene gasket door seals. NOTE: Generator exhaust shall be routed to the street side of the vehicle. 10.02 1 ACData surge suppressor for protection of entire AC power system. Product features: • UL listed: UL1449 3rd Edition • LED visual verification of status 10.03 1 LDV exclusive Intel-I-TouchTM vehicle automation control system. A multiplexed vehicle automation system must be incorporated into a common touch screen(s) that is custom programmed to monitor and control onboard systems as described throughout the specifications. The automation system software must allow simultaneous distribution of information to multiple onboard control/monitoring stations and the software must be updateable and configurable as required. This system is mandatory as it simplifies start up procedures, contains fewer operating components, reduces operational start-up time, reduces Page 11 of 19 8/17/2022 Pleasanton PD(CA)S36MCC-35149-22b REV1 DJH.docx