AGENDA FULL PACKET - Laserfiche WebLink

Page 24 102. IRRIGATION BACKFLOW PREVENTION ASSEMBLY: Irrigation Backflow preventer assembly shall be designed and installed in accordance with current City Standard Drawings 706; State Health and Safety Code (Title 17); and as required by the Public Works Department. Backflow Preventers (BFP) shall be selected from the latest “List of Approved Backflow Prevention Assemblies” available from the Foundation for Cross-Connection Control and Hydraulic Research at the University of Southern California. All backflow preventer assemblies shall be tested and certified by a City approved tester with the certification submitted to the City. Testing will be performed at the time City water is turned on to the site. An all-weather cover shall be placed over all backflow prevention assemblies 4 inches and smaller. (Address this condition prior to plan approval) 103. UTILITY ENCLOSURES: Proposed utility enclosures including vaults, meter boxes, splice boxes, and pedestals shall be installed in the public right-of-way, in a public service easement (PSE), or in a utility company specific easement. The locations for utility enclosures shall be considered in the following order of preference: (1) PSE area behind public sidewalk; (2) parkstrip area between the roadway curb & gutter and the sidewalk; (3) within the public sidewalk set flush to grade; (4) within driveway approach areas set flush to the surface with traffic-rated lids. In no case shall an above-ground pedestal or utility cabinet obstruct sight- line visibility for vehicle drivers at intersections or driveways. Above-ground pedestals or utility cabinets are preferred within the side-yard area of a corner residential lot rather than the front- yard. Deviations from this standard must be approved by the City Engineer. (Address this condition prior to plan approval) 104. DRY UTILITIES (ELECTRICITY, CATV, TELECOM): All dry utilities including electricity, telecommunications, cable television, streetlights, etc. required to serve the project shall be installed underground from the point-of-connection at the utility purveyor’s network to the service point. Aerial drops from utility poles will not be allowed. Permits 105. ENCROACHMENT PERMIT: Any work performed within the City’s right-of-way, City easements, or City-owned property shall be subject to an Encroachment Permit as defined in Pleasanton Municipal Code Chapter 13.04. All encroachment permit work is subject to adopted City of Pleasanton Standard Specifications and Details and shall be performed by properly licensed contractors as determined by the City Engineer. Said contractors must provide evidence of proper licensure (typically a Class “A” General Engineering Contractor license or appropriate Class “C” Specialty Contractor license as issued by the California Contractors State License Board), insurance and City-issued Business License upon application for a permit. (Address this condition prior to permit issuance) 106. CONSTRUCTION GENERAL PERMIT: This application is subject to a Construction General Permit according to the National Pollutant Discharge Elimination System (NPDES) General Permit No. CAS000002. The general permit is applicable to development sites that disturb one or more acres of land surface. The applicant will be required to register the project with the State Water Board’s Stormwater Multi-Application and Report Tracking System (SMARTS) website. A Qualified SWPPP Developer (QSD) and a Qualified SWPPP Practitioner (QSP) must be responsible for permit compliance. The SMARTS system will generate a Waste