AGENDA FULL PACKET - Laserfiche WebLink

P24-0596, 0 Vineyard Avenue Zoning Administrator 11 of 14 the proposed project, has been addressed as a significant effect in the prior EIR, or can be substantially mitigated by the imposition of uniformly applied development policies or standards, then an additional EIR need not be prepared for that project solely on the basis of that impact. As illustrated by the attached Consistency Checklist, the proposed project is found to be in conformance with the analysis and conclusions of the Housing Element Update FEIR. This determination is based on the following criteria: 1. There are no new significant effects peculiar to the proposed project or its site; 2. There are no new significant effects that were not previously evaluated in the Housing Element Update FEIR; 3. There are no new significant off-site or cumulative impacts that were not analyzed in the Element Update FEIR, and 4. There are no adverse impacts that are more severe than those previously identified in the Element Update FEIR. The following mitigation measures identified in the Housing Element Update FEIR are applicable to the proposed project, as described in each environmental topic: • MM AIR-1a: Prior to the issuance of a grading or building permit, whichever is sooner, the project applicant for a potential site for rezoning shall submit an air quality construction plan detailing the proposed air quality construction measures related to the project such as construction phasing, construction equipment, and dust control measures, and such plan shall be approved by the Director of Community Development or designee. Air quality construction measures shall include (1) Basic Construction Mitigation Measures, as approved by the Bay Area Air Quality Management District (BAAQMD) in 2017, or the then currently adopted guidelines, and, (2) where construction-related emissions would exceed the applicable thresholds as demonstrated by a qualified consultant conducted pursuant to methodologies considered acceptable at that time, Additional Construction Mitigation Measures, as recommended by the BAAQMD, shall be implemented to reduce emissions to acceptable levels. The air quality construction plan shall be included on all grading, utility, building, landscaping, and improvement plans during all phases of construction and for access roads, parking areas, and staging areas at construction sites. • MM AIR-1b: The following measures pertain to project sites where residences would be located within distances where the Bay Area Air Quality Management District (BAAQMD) or the California Air Resources Board (ARB) recommends not siting residential uses due to exposures to Toxic Air Contaminants. For example, the current 2005 ARB Land Use Book recommends that agencies avoid siting new sensitive land uses within 500 feet of a freeway, urban roads within 100,000 vehicles/day, or rural roads with 50,000 vehicles/day. Indoor Air Quality–In accordance with the recommendations of the BAAQMD, appropriate measures (refer to Section 5 of the BAAQMD CEQA Guidelines) shall be incorporated into building design in order to reduce the potential health risk due to exposure of sensitive receptors to TACs, including, but not limited to: A) locate sensitive receptors as far as possible within each project site from any freeways, major roadways or other non-permitted TAC sources (e.g., loading docks, parking lots);