AGENDA PACKET - Laserfiche WebLink

City of Pleasanton Villages at the Quarry Project Mitigation Monitoring and Reporting Program FirstCarbon Solutions 3 https://adecinnovations.sharepoint.com/sites/PublicationsSite/Shared Documents/Publications/Client (PN-JN)/2148/21480028/MMRP/21480028 Villages at the Quarry MMRP.docx Table 1: Villages at the Quarry Project Mitigation Monitoring and Reporting Program Mitigation Measures Method of Verification Timing of Verification Responsible for Verification Verification of Completion Date Initial III. Air Quality MM AIR-1a: Prior to the issuance of a grading or building permit, whichever is sooner, the project applicant for a potential site for rezoning shall submit an air quality construction plan detailing the proposed air quality construction measures related to the project such as construction phasing, construction equipment, and dust control measures, and such plan shall be approved by the Director of Community Development or designee. Air quality construction measures shall include (1) Basic Construction Mitigation Measures, as approved by the Bay Area Air Quality Management District (BAAQMD) in 2017, or the then currently adopted guidelines and, (2) where construction-related emissions would exceed the applicable thresholds as demonstrated by a qualified consultant documented pursuant to methodologies considered acceptable at that time, Additional Construction Mitigation Measures, as recommended by the BAAQMD, shall be implemented to reduce emissions to acceptable levels. The air quality construction plan shall be included on all grading, utility, building, landscaping, and improvement plans during all phases of construction and for access roads, parking areas, and staging areas at construction sites. Based on project- specific Air Quality and Greenhouse Gas Assessment (see Section 4.3, Air Quality, of the Consistency Checklist), the proposed project ’s air quality construction plan shall incorporate Basic Construction Mitigation Measures from BAAQMD. Incorporation into project construction documents, including all grading, utility, building, landscaping, and improvement plans; the City of Pleasanton Building & Safety Inspection Division shall inspect the worksite regularly to ensure the mitigation measures are implemented. Prior to issuance of grading or building permit, whichever is sooner; included in all plans during all phases of construction. City of Pleasanton Community Development Department: Director or designee for plan approval; Building and Safety Inspection Division for ongoing monitoring. MM AIR-1b: The following measures pertain to project sites where residences would be located within distances where the Bay Area Air Quality Management District (BAAQMD) or the California Air Resources Board (ARB) recommends not siting residential uses due to exposures The proposed project has fully complied with this mitigation measure via preparation of the project-specific Air The proposed project has fully complied with this mitigation measure via preparation of the project-specific Air City of Pleasanton Community Development Department, Planning Division