RES 2026024 - Laserfiche WebLink

on for any reason; (B) surge protection devices capable of mitigating a direct or partial direct lightning discharge; (C) surge protection devices capable of mitigating significant electrical disturbances that may enter the small wireless facility via conductive cables; (D) at least one-hour fire resistant interior surfaces to be used in the composition of all structures; and (E) monitored automatic fire notification and suppression systems for all small wireless facilities as approved by the applicable Fire Safety Authority. (11) Secondary Power Sources. The approval authority may approve secondary or backup power sources on a case-by-case basis. No permanent generators or similarly noisy or noxious generators within the public rights-of-way or at any other location or within 250 feet from any residence are permitted; provided, however, the approval authority may approve sockets or other connections used for temporary backup generators. (12) Parking. Small wireless facilities and any associated accessory equipment or other improvements shall not reduce any street parking spaces within the public rights-of-way. (13) Compliance with Laws.All small wireless facilities must be designed and sited in compliance with all applicable federal, state, regional and local laws, regulations, rules, restrictions and conditions, which includes without limitation the California Building Standards Code, Americans with Disabilities Act, the general plan and any applicable specific plan, the Municipal Code and any conditions or restrictions in any permit or other governmental approval issued by any public agency with jurisdiction over the project. (b) Antennas. In addition to all generally applicable design standards in Section 12(a), this Section 12(b) sets out specific preferences and standards for antennas. (1) Placement. Antennas should be placed above the pole, unless the approval authority finds that: (a) such placement above the pole would significantly impair views of importance, including but not limited to historic resources and scenic or historic corridors; or (b) an alternative placement, including but not limited to affixed to the side of the pole, results in an aesthetically superior design based on site-specific circumstances. (2) Stealth/Concealment. All antennas and associated cables, jumpers, wires, mounts, masts, brackets and other connectors and hardware must be installed within a unified shroud or "radome". Antenna shrouds must be visually consistent with the underlying pole's design, color and scale. Antenna shrouds placed above a pole must taper down to the point where the shroud and pole connect to conceal the cables below the antennas and create a smooth transition into the pole. All antenna mounting posts shall be trimmed so that the post does not extend above the antenna. For antennas approved to be affixed to the side of the pole within a shroud, all cables must be concealed within the Small Wireless Facilities Policy (City of Pleasanton) page 24/47