PC-2026-26 - Laserfiche WebLink

PC Resolution No. PC-2026-26 September 23, 2026 refer to Pleasanton Municipal Code Title 14. (Address this condition prior to building permit issuance) 68. BACKFLOW PREVENTION ASSEMBLIES: Backflow preventer assemblies shall be designed and installed in accordance with current City Standard Drawings 704, 705, 706; Pleasanton Municipal Code Chapter 14.16, State Health and Safety Code; State Water Resources Control Board adopted Cross-Connection Control Policy Handbook (CCCPH); and as required by the Public Works Department. Backflow Preventers (BFP) shall be selected from the latest “List of Approved Backflow Prevention Assemblies” available from the Foundation for Cross-Connection Control and Hydraulic Research at the University of Southern California. All backflow preventer assemblies shall be tested and certified by a City approved tester with the certification submitted to the City. Testing will be performed at the time City water is turned on to the site. If an existing backflow preventer is on the site, it shall be tested and certified by a City-approved tester with the certification submitted to the City before project water is drawn through it. An all-weather cover shall be placed over all backflow prevention assemblies 4 inches and smaller, and follow City Standard Specification 19-02N for backflow enclosure requirements. (Address this condition prior to plan approval) 69. SINGLE-FAMILY RESIDENTIAL FIRE PROTECTION SYSTEMS AND BACKFLOW PREVENTION: Single-family residential water services which include a fire protection system must be equipped with either Double Check (DC) valve backflow protection (requiring annual testing) or satisfy CCCPH section 3.2.2(e)(3) with pass-through/purge design of fire protection system with signage posted at fixture to bring attention to the system design with pass-through/purge. If applicant selects to install DC, assembly shall be designed and installed in accordance with current City Standards 704, 705, and PMC 14.16; including installation as close as possible to the service line before the first branch line leading off the service line. (Address this condition prior to plan approval) 70. UTILITY ENCLOSURES: Proposed utility enclosures including vaults, meter boxes, splice boxes, and pedestals shall be installed in the public right-of-way, in a public service easement (PSE), or in a utility company specific easement. The locations for utility enclosures shall be considered in the following order of preference: (1) PSE area behind public sidewalk; (2) parkstrip area between the roadway curb & gutter and the sidewalk; (3) within the public sidewalk set flush to grade; (4) within driveway approach areas set flush to the surface with traffic- rated lids. In no case shall an above-ground pedestal or utility cabinet obstruct sight-line visibility for vehicle drivers at intersections or driveways. Above-ground pedestals or utility cabinets are preferred within the side-yard area of a corner residential lot rather than the front-yard. Deviations from this standard must be approved by the City Engineer. (Address this condition prior to plan approval) 71. DRY UTILITIES (ELECTRICITY, CATV, TELECOM): All dry utilities including electricity, telecommunications, cable television, street lights, alarm systems, etc. Docusign Envelope ID: A549EA74-ED4F-8CB2-8262-A310230CC465