PC-2026-07 - Laserfiche WebLink

Small Wireless Facilities Policy (City of Pleasanton) page 27 / 47 be less aesthetically desirable considering the pole and surrounding environment. (B) Maximum Dimensions. Any base-mounted accessory equipment enclosure integrated into the pole shall not exceed the following dimensions: (i) 48 inches in height, measured from grade level to the highest point on the enclosure, but excluding any decorative design elements that transition the wider base into the narrower pole; and (ii) 26 inches in length or width on any rectangular enclosure or 28 inches in diameter for any round, hexagonal, octagonal or similarly shaped enclosure. (C) Graffiti. Base-mounted accessory equipment enclosures must be coated with anti-graffiti finishes. To prevent litter and other objects placed on such equipment, the City may require that base-mounted accessory equipment enclosures not have any flat horizontal surfaces greater than 1.5 square inches. (5) Pole-Mounted Accessory Equipment. This Section 12(c)(5) sets out specific preferences and standards for pole-mounted accessory equipment. (A) Stealth/Concealment. Applicants should propose to place any pole- mounted accessory equipment using stealth to the maximum extent feasible with concealment elements and in the least conspicuous position under the circumstances presented by the proposed pole and location. Pole-mounted accessory equipment may be installed behind street, traffic or other signs to the extent that the installation complies with applicable public health and safety regulations. Unless placed behind a street sign or some other concealment that dictates the equipment orientation on the pole, all pole-mounted accessory equipment should be oriented away from prominent views. In general, the proper orientation will likely be toward the street to reduce the overall profile when viewed from the nearest abutting properties. If orientation toward the street is not feasible, then the proper orientation will most likely be away from oncoming traffic. If more than one orientation would be technically feasible, the Director may select the most appropriate orientation. (B) Minimum Ground Clearance. The lowest point on any pole-mounted accessory equipment shall be at least 15 feet above ground level adjacent to the pole. If applicable laws require any pole -mounted accessory equipment component to be placed less than 15 feet above ground level, the clearance from ground level shall be no less than required for compliance with such laws. (C) Horizontal Extensions. Pole-mounted accessory equipment should be as close to flush with the pole as technically feasible and shall not extend over Docusign Envelope ID: 51CE5BDE-55F1-4B3D-8865-17E5814CF0C5