Laserfiche WebLink
1 Sequoia Ecological Consulting,Inc. <br /> CaIVTP Project-Specific Analysis and Addendum C i6 <br /> Augustin Bernal Community Park Fuel Reduction <br /> November 2025 <br /> • Manual and Herbicide Treatment Activities <br /> o Scrub would be retained in a natural mosaic through the removal of invasive species,thinning out <br /> dead branches from shrubs, and limbing up large shrubs <br /> o Small encroaching trees(under 6 inches DBH) may be removed,and limbs would be removed from <br /> larger trees up to 6 feet, as appropriate <br /> o Cut vegetation would be lopped and scattered,chipped and broadcast, pile burned,or hauled off- <br /> site <br /> o Broom plants or other invasive shrubs and noxious weeds would either be uprooted and pulled or <br /> cut low to the ground and spot treated with herbicide <br /> o Herbicide spot treatment of invasive species and noxious weeds would be hand-applied <br /> • Prescribed Herbivory Treatment <br /> o Goats, cattle, or other grazing animals would be installed strategically within areas with wildlife- <br /> safe fencing or existing barriers <br /> o A professional shepherd would coordinate animal movements to prevent excessive grazing and <br /> ground disturbance <br /> • Biomass Disposal <br /> o Biomass from non-invasive, non-noxious plants would be left to naturally decompose (e.g., lop <br /> and scatter, chip and broadcast), pile burned, or hauled off-site <br /> o Poison oak would be cut and left in place(lop and scatter) <br /> o Where chipper access is not practical, cut material would be piled strategically for later burning <br /> o Within suitable habitat for Alameda whipsnake, piles left in place for a critical length of time as <br /> determined by a professional would be dismantled and reconstructed prior to burning <br /> Tree Fuel Type Treatment Activities <br /> Tree fuel types would include habitat classified by the CWHR as blue oak woodland and coastal oak woodland.The <br /> general approach to tree fuel types would be designed to prevent fire from approaching or departing the fuel <br /> break, prevent fire from laddering into the tree canopy, and promote establishment of native trees. Selective <br /> thinning would result in a shaded fuel break that retains the tree canopy.This would be achieved through removal <br /> of select trees, branches, shrubs, and both living and dead vegetation that could facilitate the upward spread of <br /> fire from surface fuels to the forest canopy.The shade of the retained canopy would reduce the potential for rapid <br /> re-growth of understory, and the selectively treated areas would provide firefighters an opportunity to access <br /> lower-intensity ground fires, should they occur. Within all wooded areas,vegetation removal would be addressed <br /> primarily with manual treatment activities to preserve a natural appearance. Other treatment activities used <br /> within forest fuel types would include mechanical equipment, herbicides, prescribed herbivory, and prescribed <br /> burning. <br /> • Manual Treatment Activities <br /> o Hand-held tools would remove and thin understory shrubs and brush, as well as dead and dying <br /> trees and small (less than 6 inches DBH) non-native, invasive trees <br /> o Lower tree limbs would be pruned, and most ground vegetation would be removed to break up <br /> the horizontal and vertical continuity of flammable vegetation <br /> o Invasive species and noxious weeds would be strategically removed first, followed by fire-prone <br /> native species, such as oak, pine, coffee berry(Frangula spp.), sage, etc. <br />