12 ATTACHMENTS - Laserfiche WebLink

A.6.b Visitors standing outside a unit's door must be visible inside the unit, even for children or the disabled. This requires double peep holes, doors with clear windows, or side windows that allow inside residents at all heights to view and identify callers. (1 Points) Verification: Plan notes and a final inspection of residence entries from the Building and Safety Division shall be required A.8.b This point applies to non residential spaces only. Typically only applicable on projects with more than 10% conditioned floor area dedicated to non residential uses. (28 Points) Build to exceed the Title 24, Part 6 (2005) building code that mandates minimum energy efficiency in buildings. A Title 24 report showing the percentage above code in the form PERF -1 for non residential portions of the buildings shall be required. If the project uses energy modeling (computer simulation) to show performance above Title 24 minimums, then the final simulation report (approved by the Building and Safety Division) must be used to show evidence of beating the Title 24. The report must include actual building components and HVAC systems included in the final building design (i.e. simulation is run off of plans at least at the 100% Construction Documents phase). If more than one Title 24 report is available for the non- residential portions of the project, enter the combined weighted average (based on square footage) of percent above code for the various reports. Verification: The Building and Safety Division will review Title 24 report(s) found on the building plans showing percent above Title 24. Submittal of the calculations for average percent above Title 24 (if applicable) shall also be required. Electronic copies of the CF-1R or PERF -1 forms may be required. B.2.a This point applies to all floor, wall and roof framing, excluding roof trusses. 80% or more of framing materials will be delivered to the job -site pre -cut or pre assembled from supplier (determined by board -foot or as a percentage of total framing material cost). This includes interior and exterior studs, headers, joists, beams, posts /columns, and more (excluding roof trusses). Steel framing or other pre assembled components can be included in this measure if the components do not include insulation. Note: Pre fabricated walls, floors or roofs that have insulation installed, such as SIPs or other pre -made building systems are not eligible for this measure, but are eligible for measure C.7. Civic Square Apartments 6 of 14 Multifamily GreenPoint Comments 4800 Bernal Avenue PUD- 84- 21 -01M