Laserfiche WebLink
(1 Point) <br />B.2.b At least 25% of the total building square footage will come from pre- manufactured <br />and complete building components (are finished or nearly finished), such as modular <br />bathrooms, bedrooms, kitchens or other rooms. <br />(2 Points) <br />C.3.b This point applies to wood framing on wood- framed buildings only. Forest <br />Stewardship Council (FSC) certified wood shall be used for at least 40% of all panel <br />products (OSB and /or plywood), calculated by square- footage of sheet goods. <br />Verification: A rough inspection from the Building and Safety Division (to verify the <br />FSC label) and submittal of FSC chain -of- custody certificates (or other <br />FSC verification method; such as invoices) to substantiate calculations <br />shall be provided. <br />*(2 Points) Dependent on percentage achieved <br />C.4.a At least 90% of all floor and ceiling joists with engineered lumber or steel, calculated <br />by linear feet or cost, shall be required. Pre assembled components (framing without <br />insulation) are allowed to be included in this measure. <br />(1 Point) <br />C.5.b Ensure that framing places are appropriately -sized for headers in each location. The <br />Building Inspector should be able to see distinctly different header sizes based on <br />different placements within the building. SIPS or other solid wall assemblies do not <br />achieve points under this measure. Pre fabricated components (insulated or not) <br />can achieve this measure if the OVE strategy is verifiable. <br />(1 Point) <br />Verification: Plan notes and documentation showing that 80% of lumber is pre -cut <br />when delivered. A rough inspection from the Building and Safety <br />Division will be required. <br />Verification: Provide documentation showing that building components are pre <br />assembled off-site and delivered to the project, along with percentage <br />of floor area calculations. A rough inspection, to see delivery and /or <br />installation of components or modules, from the Building and Safety <br />Division will be required. <br />Verification: A rough inspection from the Building and Safety Division. <br />Verification: Plans submitted to the Building and Safety Division are required to <br />have plan notes to verify header schedule for load bearing walls. A <br />rough inspection from the Building and Safety Division to verify that the <br />headers in non -load- bearing walls are 4 "x4" or less and that the <br />headers in bearing walls match the structural schedule. <br />Civic Square Apartments 7 of 14 Multifamily GreenPoint Comments <br />4800 Bernal Avenue PUD- 84- 21 -01M <br />